How to Set Up Motion Detection in QNAP

 

After you have set up your Reolink camera in QNAP, please follow the below steps to set up motion detection:

Step 1. Go to Surveillance Station.

Go To Surveillance Station

Step 2. Check “Enable alarm recording” in “Event Management“, and then click “Apply” to save the settings.

 Enable Alarm Recording

Step 3. When motion is detected, you will see a “red running man” and get an event notification on the live view page. If you want to view the details of the event notification, click the notification icon.

 Red Running Man and Event Note

Note: If you have already finished the above settings, but still can not see the note box, please open “Options” and check “Enable alert for all surveillance events”.

 Enable Alert for All Surveillance Events

After you have finished the above steps, “A” will turn red when motion is detected.

 A Turns Red

If you experience any problems, please contact us for further support.

Applies to:

All Reolink cameras

in ONVIF Software